FabCafe in Shibuya , Japan
generated a lot of talk amongst coffee lovers and designers alike, when it
opened in early 2012. The name has a double meaning : the more obvious
contraction of the word fabulous, and the less-obvious contraction of the word,
fabrication. FabCafé, comes with a laser cutter which, for a fee, anyone can
use. However, it’s recommended you have your coffee before operating the machine.
All you need to bring is an
adobe illustrator vector file, which you plug in to the cutter it does the work
– in paper, felt, acrylic, wood and other materials too. Pricing to use the
machine is a bit steep, but not outrageous : 2000 yen to share the machine with
up to 3 people for 30 minutes. It will cost you 5000 yen if you want the
machine to yourself.
FabCafe was designed by Naruse-Inokuma Architects. The
laser cutter is the VLS6.60 from ULS (Yokohama ).
Here are the specs if you’d
like to do your homework before you go.
During this past Valentine’s
day (which is rather popular in Japan, by the way, with ladies offering special
chocolate treats to gentlemen), the people from FabCafe set up a workshop,
where they would first scan your face in a 3D body scanner, then use the
contour to print a silicon mold-set on a 3D printer. Chocolate was poured in
the mold, and after set, voilà ! your fully featured (and quite detailed) face.
Check out the images and video from here.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.